home *** CD-ROM | disk | FTP | other *** search
- SEAGATE TECHNOLOGY, INC.
- Customer Technical Support FAX Network +1 408 438-8137
- Customer Technical Support Bulletin Boards (300-9600, 8-N-1)
- ┌──────────────────────────────────┬─────────────────────────────────┐
- │ United States +1 408 438-8771 │ United Kingdom +44 628 478011 │
- ├──────────────────────────────────┼─────────────────────────────────┤
- │ Germany +49 89 140-9331 │ Singapore +65 227-2217 │
- └──────────────────────────────────┴─────────────────────────────────┘
- (C)opyright 1991
-
-
-
- ST-1133A (94354-133) Swift AT (IDE)
- ┌───\
- │ O │ 5
- │ O │ G ┌─┐ Some have
- │ O │ G AT (IDE) Cable │ ├─ these pins
- │ O │ 12 1┌........................┐ o o o o o(o o)
- └───/ ........................ o o o o o(o o)
- ═══════════════════════════════════════════════════════
- 1 2 3 4 5 6 7
- ON OFF │ │ │ │ │ └┬┘
- 1 Slave Master ──┘ │ │ │ │ │
- 2 5 Heads 7/9 Heads ────┘ │ │ │ │
- 3 Slave installed Slave not inst. ──────┘ │ │ │
- 4 7 byte ECC 4 byte ECC ────────┘ │ │
- 5 Factory test Normal Oper. ──────────┘ │
- 6/7 Some PWA's have these pins, factory use ───────┘
-
-
- ST-1133A
- 94354-133 Swift
-
- UNFORMATTED CAPACITY (MB) ________________133
- FORMATTED CAPACITY (36 SECTORS) (MB) _____117
- ACTUATOR TYPE ____________________________VOICE COIL
- TRACKS ___________________________________6,360
- CYLINDERS ________________________________1,272
- HEADS ____________________________________5
- DISCS ____________________________________3
- MEDIA TYPE _______________________________THIN FILM
- RECORDING METHOD _________________________RLL
- TRANSFER RATE (mbytes/sec) _______________1.25
- SPINDLE SPEED (RPM) ______________________3,600
- BUFFER ___________________________________32 or 64 Kbyte
- Read Look-Ahead, Non-Adaptive,
- Single-Segmented
- INTERFACE ________________________________AT BUS
- TPI (TRACKS PER INCH) ____________________1,350
- BPI (BITS PER INCH) ______________________28,103
- AVERAGE ACCESS (ms) ______________________15
- SINGLE TRACK SEEK (ms) ___________________4
- MTBF (power-on hours) ____________________150,000
- POWER REQUIREMENTS: +12V START-UP (amps) _2.5
- +12V TYPICAL (amps) __0.7
- +5V START-UP (amps) __0.75
- +5V TYPICAL (amps) ___0.4
- TYPICAL (watts) ______11
- MAXIMUM (watts) ______33.75
- BUFFERED STEP PULSE RATE (micro sec) _____6-200
- WRITE PRECOMP (cyl) ______________________N/A
- REDUCED WRITE CURRENT (cyl) ______________N/A
- LANDING ZONE (cyl) _______________________AUTO PARK
- IBM AT DRIVE TYPE ________________________*
-
- * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO
- SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE
- AVAILABLE. (see below)
-
- Possible translation: 636 cyl, 10 heads, 36 sectors = 117,227,520
- Possible translation: 477 cyl, 8 heads, 60 sectors = 117,227,520
- Possible translation: 962 cyl, 14 heads, 17 sectors = 117,225,472
- Possible translation: 629 cyl, 14 heads, 26 sectors = 117,225,472
-
- Note: A "custom" or "user-definded" CMOS drivetype may ask for a
- numerical value for the Write Precompensation cylinder and for the
- Landing Zone cylinder. A basic rule-of-thumb for drive models that do
- not require the old Write Precomp technique or a Landing Zone because
- they are Auto-Parking is to add 1 to the cylinder value being used. As
- an example: If cylinders equaled 820, then both Write Precomp and
- Landing Zone would be entered as 821. Some BIOS will convert this to
- 65535 or -1, which are functionally equivalent to "none (not used)".
-
- PHYSICAL/LOGICAL equivalent to NATIVE/TRANSLATION
-
- Already low-level formatted at the factory.
-
- Since a User-definable or Custom translation geometry may be used, it
- is imperative that the values be written down and kept with your
- permanent records for retrieval in the event of CMOS battery failure.
-
-
- Swift Remote LED Option
-
- Front View of Drive Without the Plastic Bezel
-
- ┌───┬───┐
- │ A │ B │ B = Anode
- ├───┼───┤ D = Cathode
- │ C │ D │
- ...═════════════════╧═══╧═══╧═════P═W═A═══...
-
-
- ° Default jumper at C-D for LED mounted on drive PWA
- ° To use remote LED, remove jumper and extend B (Anode)
- and D (Cathode).
- ° Swift LED kit 75912397 allows connection to a remote LED
- ° Swift LED kit 95913369 has an LED for attachment to the
- system front bezel or a 5.25-inch frame kit
-
- Seagate reserves the right to change, without notice, product
- offerings or specifications. (6/26/90)