home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Shareware Supreme Volume 6 #1
/
swsii.zip
/
swsii
/
165
/
HPEISA.ZIP
/
INSTALL.DOC
< prev
Wrap
Text File
|
1990-09-21
|
1KB
|
23 lines
This file describes the installation of the DTC6290E EISA board in the
Hewlett Packard EISA machine.
1) Rename the file !DTC0102.HP to the filename !DTC0102.CFG.
2) Replace the original file !DTC0102.CFG that came with your DTC6290E
controller card with the file you just renamed.
3) When running the EISA configuration file that came with the Hewlett
Packard machine, add one of the ISA controller files into the setup as
though the controller was really in the machine. Set the system up so
the controller is in one of the unused slots of the machine. Set the
system up for the primary port base (1f0-1f7) and IRQ14. Set the drive
type to user defined and fill in the blanks for the drive that will be
attatched to the DTC controller. The values to be filled in should
depend on the drive and the translation mode. This is described in
the DTC installation manual that came with the controller.
4) Now, add the DTC controller to the slot that it is really in and
save the configuration and reboot the system. The remainder of the
installation should be the same as described in your DTC installation
guide.