home *** CD-ROM | disk | FTP | other *** search
-
- SERVICEPAK XR06200
- __________________
-
-
-
- GENERAL INSTALLATION INFORMATION
-
- Before installing XR06200, run CHKDSK /F on your OS/2
- partition to ensure that your system does not currently
- have any corrupted files. To run CHKDSK:
-
- 1. Insert the base operating system Installation
- Diskette (not the ServicePak Installation Diskette)
- into drive A.
- 2. Shut down and restart the system.
- 3. When the IBM screen appears, remove the Installation
- Diskette and insert the base operating system
- Diskette 1; then press Enter.
- 4. When the Welcome screen appears, press Esc to display
- the command prompt.
- 5. Remove Diskette 1 and insert base operating system
- Diskette 2.
- 6. Type "CHKDSK x: /F"
- (where x is the drive letter of your OS/2 system par-
- tition).
-
- Diskette Installation
-
- If you are installing from the XR06200 Installation
- Diskettes, you can choose from the following two
- procedures:
-
- PROCEDURE 1: INSTALLING ALL CHANGES TO ALL PARTITIONS.
- Use this procedure if you want to apply the service
- updates to all the partitions that contain OS/2 2.1. If
- your system has an AOX adapter installed, you should use
- this procedure.
-
- PROCEDURE 2: INSTALLING ALL CHANGES TO THE SELECTED PAR-
- TITIONS. Use this procedure if you do not want to apply
- the service updates to all the partitions that contain
- OS/2 2.1.
-
- PROCEDURE 1: INSTALLING ALL CHANGES TO ALL PARTITIONS
-
- NOTE: Dual Boot users must boot into OS/2 prior to fol-
- lowing this procedure.
-
-
- 1. Shut down your system. Do not go back to DOS if con-
- figured as a Dual-Boot system.
- 2. When the shutdown is complete, insert ServicePak
- XR06200 Diskette 1 into drive A.
- 3. Press Ctrl+Alt+Del.
-
- PROCEDURE 2: INSTALLING ALL CHANGES TO SELECTED PARTI-
- TIONS
-
- 1. Select an OS/2 command-prompt object from the Command
- Prompts folder in the OS/2 System folder.
- 2. Insert the ServicePak Diskette 1 into drive A.
- 3. Type "A:\SERVICE" at the OS/2 command prompt; then
- press Enter.
- 4. Select OK to display a list of the OS/2 2.1 products
- installed on your system. (For example, if OS/2 2.1
- is in more than one partition, the OS/2 2.1 base
- product will be listed and selected more than once.)
- 5. Deselect one or more products that you do not want to
- update.
- 6. Select Service and then select Continue to update all
- directories in each selected product. If you do not
- want to update all directories in each selected
- product, select Cancel.
- 7. Follow the instructions on the screen to complete the
- installation.
-