6 Scanner Reports an ADF Paper Jam, Please clean the feeder to continue.
7 Scanner Reports the ADF is Open, Please check the feeder to continue.
8 Scanner Reports the ADF is empty, Please insert some paper to continue.
9 Scanner Reports an Undefined Medium Error. Please Check the ADF.
10 ADF Problem
11 No Sense Key Information
12 Device Reports Not Ready
13 Device Reports a Paper Jam
14 Device Reports the Feeder is Open
15 Device Reports the Document Chute is Empty
16 Device Reports an Abnormal Internal Target
17 Device Reports a Parity Error
18 Device Reports an Invalid Command
19 Device Reports an Invalid CDB
20 Device Reports an Unsupported LUN
21 Device Reports an Invalid Field in the Parameter List
22 Device Reports Unit Attention
23 Unit Reports a Message Error
24 SenseKey:
25 Additional Sense:
26 Additional Sense Qualifier:
27 Device Reports Unknown Sense Information
28 Sense Information:
29 Interpretation:
30 Host reports no error
31 Host Reports a selection timeout
32 Host report Data Underflow/Overflow
33 Device reports a check condition
34 Device reports busy
35 Device reports no error
36 Target status is unknown
37 Host status is unknown
38 Transport Information:
39 Host State:
40 Target State:
41 ICAP_XNATIVERESOLUTION
42 ICAP_YNATIVERESOLUTION
43 ICAP_THRESHOLD
44 ICAP_AUTOBRIGHT
45 ICAP_BRIGHTNESS
46 CAP_REWINDPAGE
47 CAP_FEEDERLOADED
48 CAP_FEEDPAGE
49 CAP_CLEARPAGE
50 ICAP_SUPPORTEDCAPS
51 CAP_AUTOFEED
52 Device Reposrts a Abnormal Light Dose
53 Device Reports a Trouble by Transporting
54 Device Reports a Blown Fuse for ADF
55 Device Reports a Blown Fuse for heater
56 Device Reports a Blown fuse for carrier
57 Device Reports a Wrong window combination
58 Device Reports a Message Error
59 Device Reports a Image Transfer Error
104 Settings
105 Image
107 Custom
110 COLOR
117 Red
118 Green
119 Blue
120 Brightness
121 Contrast
122 Threshold
123 Custom
124 ValidDeviceIDs
125 ValidLuns
126 Pattern 1
127 Pattern 2
128 Pattern 3
129 Pattern 4
131 M3096HX
132 M3096GX
133 Custom
134 There was a problem loading CRLASP16.DLL.
135 Please remove paper from the sheet feeder.
136 No Status Info
137 No Memory Reported from SCSI
138 Alloc Failed Reported from SCSI
139 SCSI Error
140 An unknown error was reported from SCSI.
141 Low memory was reported from SCSI.
142 Cancel Error
143 Cancel was not successful.
144 M3096G
145 M3096H
146 M3093
147 M3097
148 M3097G
149 M3096Gm
150 M3096Hm
151 M3097Gm
152 Error Diffusion
153 Normal
154 Sharp
155 Soft
156 None
157 Low
158 Medium
159 High
160 Smoothing
161 Unknown
162 A serious error has occurred, but the cause is not known.\nPlease make sure your Scanner is connected correctly\nand that your system resources are not low.
163 Error
7024 SCSI
7025 The width you have selected is too large for this unit at this resolution.\nAdjust automatically?
