home *** CD-ROM | disk | FTP | other *** search
/ IBM Presents OS/2 Software Hits 1995 / OS-2_SW_HITS_2ND_EDITION_1995.ISO / i18 / nec260.txt < prev    next >
Text File  |  1994-12-08  |  2KB  |  55 lines

  1. TITLE: 941114 Configuring the NEC 260 IDE cdrom under OS2 Warp.
  2.  
  3. DESCRIPTION OF SYMPTOMS:
  4.     A NEC 260 IDE cdrom is not being recognized by OS2 Warp.
  5.  
  6. SUMMARY OF RESOLUTION:
  7.     Make sure the proper drivers are loading in config.sys and
  8.     that the necessary files are located in the proper directories.
  9.  
  10. DETAILS OF RESOLUTION:
  11.     If you have already installed OS2 Warp, and are trying to get
  12.                the cdrom recognized, follow these instructions:
  13.  
  14.      1. Go to the OS2 Selective Install utility. From the list of
  15.         cdrom's, select the NEC 260. Click OK. At the System
  16.         Configuration window, click OK again. At the Setup and
  17.         Installation window, select the Install button.
  18.  
  19.      2. Insert the OS2 diskette when prompted.
  20.  
  21.      3. Edit the OS2 config.sys in the root directory of the hard
  22.         drive. Find the line:
  23.  
  24.                           BASEDEV=IBM1S506.ADD
  25.  
  26.         Add switches to this line so that it reads:
  27.  
  28.                           BASEDEV=IBM1S506.ADD /A:x /U:y /ATAPI
  29.  
  30.         The /A switch refers to the adapter number that the cdrom
  31.         is attached to. The /U option references the unit or device
  32.         number on a particular adapter. The /ATAPI parameter
  33.         enables ATA Packet Interface protocol for the NEC 260. If the
  34.         cdrom is attached to the second IDE port or adapter in a
  35.         system and is the only device on the adapter, you would enter
  36.  
  37.                           BASEDEV=IBM1S506.ADD /A:1 /U:0 /ATAPI
  38.  
  39.         in the config.sys. If the cdrom is configured as a slave, or sec
  40.         device, you would specify /U:1. The config.sys should also conta
  41.         the statements:
  42.  
  43.                            BASEDEV=IBMIDECD.FLT
  44.                            DEVICE=C:\OS2\BOOT\OS2CDROM.DMD
  45.                            IFS=C:\OS2\BOOT\CDFS.IFS
  46.  
  47.          These should have been added by the Selective Install program.
  48.  
  49.          If you are trying to install Warp from the NEC 260 cdrom,
  50.          simply configure the BASEDEV=IBM1S506.ADD  line per above.
  51.          If you find that OS2 still does not recognize the cdrom,
  52.          make sure that the /A and /U parameters are specified
  53.  
  54.  
  55.