home *** CD-ROM | disk | FTP | other *** search
-
- 5.4.4 CHANGE ARC
-
-
- The CHANGE ARC command is used to change various parameters of an arc or
- a circle.
-
-
- COMMAND FORMAT
-
- #CHANGE ARC modifiers :Ent x1 ... xn
-
-
- MODIFIERS
-
- At least one of the following modifiers must be entered. Action is only
- taken for the modifiers that are entered, parameters not changed will
- remain as they are.
-
- RADIUS Requires a real value defining a new arc radius. ( See fig. 5.36
- ).
-
- STARTANG Requires a real value defining the new arc start angle in
- degrees. ( See fig. 5.37 ).
-
- ENDANG Requires a real value defining the new arc end angle in degrees.
-
-
-