home *** CD-ROM | disk | FTP | other *** search
- @CLS
- rem *** This file will download the file FLTSIM4A.ADV & switch to
- rem C:\REMAP & run the file FS4RMPA.BAT which will load
- rem FLTSIM4A.RMP and will load the TSR, and then switch to
- rem C:\FLTSIM4 directory and run FS4. When you exit
- rem FS4, FS4RMPA.BAT will remove the remap TSR.
- Pause
- CLS
- rem *** If you find the remap TSR is not working, make sure you
- rem have C:\REMAP in your path statement in AUTOEXEC.BAT.
- rem If you have already downloaded FLTSIM4A.ADV previously,
- rem hit Ctl-C and then answer Y to the terminate question.
- rem Then switch to the C:\REMAP directory & run FS4RMPA.BAT.
- Pause
- @CLS
- rem *** Place the RED mode switch in DIGITAL and the BLACK mode
- rem switch in DIGITAL mode.
- rem *** After you enter FS4, you will be using ANALOG throttle
- rem so choose Option C. for Joystick - Stick A - Yoke,
- rem Stick B - Throttle/Rudders. Yes, even if you don't have
- rem rudders, as long as you have the ThrustMaster WCS II
- rem and FCS or PFCS it will work. If you do have the
- rem ThrustMaster RCS, Option C. will work as well. ***
- pause
- @CLS
- rem Use the FS4 menu option 4 - E to set the joystick and
- rem throttle and rudder (if you have them) sensitivities until
- rem your controls respond the way you prefer, that's what the
- rem option 4 - E is there for.
- Pause
- @CLS
- rem *** If, for example, when you push the throttle to full
- rem travel, you do not get full throttle travel, then
- rem adjust the sensitivity setting for throttle in menu
- rem option 4 - E to a higher number until the throttle is
- rem responding properly. I have a 486/66 and I set the
- rem throttle sensitivity to 6. This gives me a throttle
- rem response I like. Do the same for any other controls
- rem you have.
- Pause
- @CLS
- rem *** You will be told to click button one on the WCS II
- rem YOU MAY HAVE TO CLICK IT MORE THAN ONCE EACH TIME!!! ***
- rem *** ONLY CLICK BUTTON 1 WHEN YOU ARE TOLD TO DO SO - otherwise
- rem hit a key on your keyboard at all pause messages. *****
- Pause
- @CLS
- rem *** CLICK BUTTON 1 ON THE WCS II HANDLE UNTIL THE DOWNLOAD STARTS
- rem and you get a message to change the RED WCS II mode switch to
- rem the CALIBRATE POSITION WHEN IT TELLS YOU TO PRESS ANY KEY
- rem AFTER THE PAUSE MESSAGE ***
- Pause
- @CLS
- DOWNLOAD FLTSIM4A.ADV
- @CLS
- @CD\REMAP
- @FS4RMPA
-
-