14 [3][$E| |The copy operation was|aborted because it was|in an endless loop!][OK]
15 [3][$E| |Memory problem! Archive|contains too many files...][OK]
16 [3][$E| |Delete all selected files|$T?][Cancel|Delete]
20 [1][$E|Because MAG!X doesn't support|ARGV, you have selected too|many files. Choose the 'No|multitasking' option.][OK]
21 [3][$E|ST-GUIDE not found! Install|as an accessory or use the |'Viewer...' dialog to run|it as a program...][OK]
22 [3][$E|Better use the TTP version|here, otherwise the archiver|output cannot be redirected|by Two-in-One!][OK]
23 [3][$E The dialog will con-|tain meaningful 'quickstart'|entries. All you need to do|is set the paths so Two-in-|One can find each program...][Cancel|OK]
24 [3][$E|Note: Maybe Lharc did not find|any file because you haven't|specified the 'x' option!...][OK]
'---------------------------------
#TOS
-1 General error
-2 Drive not ready
-3 Unknown command
-4 CRC error|disk check sum wrong
-5 Bad request
-6 Seek error|track not found
-7 Unknown media|boot sector wrong
-8 Sector not found
-9 Out of paper
-10 Write fault
-11 Read fault
-12 General error 12
-13 Write protected
-14 Media change detected
-15 Unknown device
-16 Bad sector (verify)
-17 Insert other disk|(request)
-32 Invalid function number
-33 File not found
-34 Path not found
-35 Too many open files
-36 Access denied
-37 Invalid handle
-39 Out of memory
-40 Invalid memory block address
-46 Invalid drive specification
-49 No more files
-64 GEMDOS range error|seek wrong?
-65 GEMDOS internal error
-66 Invalid executable file format
-67 Memory block growth failure
'---------------------------------
#LZH
1 Bad Table
2 CRC Error
4 Write-Error
8 Read-Error
16 Can't rename file or|create folder
32 Can't copy/create|temp. archive
64 Not implemented command
128 No LHarc-archive/|no archivname
256 File not found/|No file specified
512 Not enough memory
1024 Garbage found and skipped
2048 Garbage found at the|archive-end
'---------------------------------
#ZIP
1 not enough memory
2 file not found
3 illegal option
4 two actions specified
5 no zip file specified
6 no command specified
7 error reading
8 this file is not|a zip file
9 error writing
11 warning during ex-|traction (read/write|error, CRC error ...)
12 warning during com-|pression
13 error while copying|temp zip file to|original zip