|
Standard Generator Parameters
|
|
|
|
|
|
Amplitude
|
Describes the function height above and below the horizontal axis. The default value is 50.0%. Increase the function height up to 100.0% or it flatten out at 0.0%.
|
|
|
|
|
|
Shift
|
Repositions the function vertically, above or below its default position on the horizontal axis. At 100.0% the function is entirely above this axis; at 0.0% it's entirely below. The default
is 50.0%.
|
|
|
|
|
|
Frequency
|
Compresses the function horizontally when the value is greater than the default of 1.0. Or stretches the function horizontally when the value is less than 1.0.
|
|
|
|
|
|
Phase Amount
|
Phase repositions the function along the horizontal axis. Phase Amount gives a percent value for the phase range set by Phase Min and Phase Max.
|
|
|
|
|
|
Phase Min
|
Sets one end of the phase range.
|
|
|
|
|
|
Phase Max
|
Sets the other end of the phase range.
|
|
|
|
|
|
Lower Clamp
|
Controls the minimum function value. The default is 0.0%.
|
|
|
|
|
|
Upper Clamp
|
Controls the maximum function value. The default is 100.0%.
|
|
|
|
|
|
Invert
|
When enabled, flips the function about the horizontal axis.
|
|
|
|
|
|
Reverse
|
When enabled, reverses the function. For symmetrical functions, you may not see the difference.
|
|
|
|
|
|
Input
|
Function re-mapping input. Link this to an linear time component to shift the function into the time domain.
|
