![]() | ![]() |
|
![]() |
|
Right-click the DeviceMaster LT for which you want to program network information and click the Properties option.
Optionally, rename the DeviceMaster LT in the Device Name field. A Device Name is required. The default name is Device and the last three octets of the MAC address.
![]() |
|
Select the appropriate Detection Type:
REMOTE means that the DeviceMaster LT is not connected to this segment of the network and it uses IP communications, not MAC communications.
LOCAL means that the DeviceMaster LT is on this local network segment and uses MAC communications. An IP address is not required but Technical Support recommends using an IP address.
Change the DeviceMaster LT network properties as required for your site.
If you want to run the DeviceMaster LT using the MAC addressing scheme, click Disable IP.
To use the DeviceMaster LT with DHCP, click DHCP IP, and make sure that you provide the MAC address of the DeviceMaster LT to the network administrator. Make sure that the administrator reserves the IP address, subnet mask and gateway address of the DeviceMaster LT in the DHCP server.
To program a static IP address, click Static IP and enter the appropriate values for your site.
Click Apply Changes to update the network information on the DeviceMaster LT.
Optionally, refer to the DeviceMaster LT User Guide for procedures to program the IP address in the DeviceMaster LT with RedBoot.
After configuring the network, you are ready to check the firmware versions and possibly update the firmware before configuring the ports.
![]() |
![]() | 06/11/14 | Home | Comtrol Support | ![]() | |
![]() | Copyright © 2014 Comtrol Corporation. | ![]() |