[<<Previous Entry]
[^^Up^^]
[Next Entry>>]
[Menu]
[About The Guide]
ZIP2EXE Error Messages
ZIP2EXE: (E01) Error in .ZIP file
ZIP2EXE: (E02) Error in .ZIP file, use PKZIPFIX
The .ZIP file you are attempting to process is corrupt. You may attempt
recovery of the file by using PKZIPFIX. PKZIPFIX will work on either
standard .ZIP files or self-extracting .EXE files.
ZIP2EXE: (E03-04) Insufficient memory to process file
The .ZIP file you are attempting to process is too complex. This may
indicate a .ZIP file which contains too many files. In some cases you may
receive this error because the file being processed is corrupt.
ZIP2EXE: (E07) Can't open Source file
The source .ZIP or .EXE file specified on the command line cannot be
opened due to a disk error or insufficient network access.
ZIP2EXE: (E08) Error in .ZIP file
The .ZIP file you are attempting to process is corrupt. You may attempt
recovery of the file by using PKZIPFIX. PKZIPFIX will work on either
standard .ZIP files or self-extracting .EXE files.
ZIP2EXE: (E09) Disk full writing target file during EXE to ZIP process
ZIP2EXE: (E11) Disk full writing target file during ZIP to EXE process
During the process of converting a file there must be enough disk space
available to contain both the original file and the file which will be
created. If there is not enough room to process the file on the current
drive you may direct the output to another drive by specifying it on the
command line.
ZIP2EXE: (E12) Compression method not supported
The .ZIP file being converted contains a file compressed with a method not
supported by the version of PKSFX being attached by ZIP2EXE.
You can only perform the ZIP2EXE process on .ZIP files created using the
compression method(s) supported by the self-extracting module you are
attaching.
This page created by ng2html v1.05, the Norton guide to HTML conversion utility.
Written by Dave Pearson