home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Shareware Overload
/
ShartewareOverload.cdr
/
graf
/
dancad2.zip
/
README.BAT
< prev
next >
Wrap
DOS Batch File
|
1988-01-01
|
3KB
|
57 lines
ECHO OFF
CLS
REM Copyright (c) 1988 by DANIEL H. HUDGINS, All Rights Reserved
REM README.BAT for DANCAD3D.COM v2.0
Echo DANCAD3D by Daniel H. Hudgins, 466 Diamond St., San Francisco, CA 94114
Echo .
Echo To use DANCAD3D v2.0 you need:
Echo * 512KB to 640KB DOS memory, at least 384KB or more of it as free memory.
Echo * a CGA, Color Graphics Adapter video board or
Echo * a EGA, Enhanced color Graphics Adapter video board or
Echo * a Hercules (tm), Monochrome Graphics Card type video board.
Echo * a HARDDISK, RAM disk, or other disk of 720KB or more free disk space.
Echo * DOS 2 or higher and a fully IBM compatible computer.
Echo .
Echo Make a back-up copy of these two 360KB disks or this one 720KB disk.
Echo Enter COPY A:*.* B: with the blank formatted disk in drive B: & DANCAD3D in A:
Echo .
Echo To print the *.DOC file: Shift the paper 1/2 inch to the left then,
Echo Put the SECOND disk in drive A:, then enter:
Echo COPY A:DANCAD3D.DOC PRN (for the parallel printer)
Echo or
Echo COPY A:DANCAD3D.DOC AUX (for the RS-232C serial printer)
Echo .
Echo The *.DOC has brief information to get you started using DANCAD3D. A 300+
Echo page manual comes with the set of 14 disks that can be ordered from the author
Echo using the order form in the forth screen of the program.
Echo .
Pause
CLS
Echo To install DANCAD3D on your HARDDISK enter INSTALL C, where C is the letter
Echo for your harddisk, from the DOS prompt with the DANCAD3D disk you got (ether
Echo one if you got two 360KB disks) in your floppy drive A when you are set to
Echo the A drive prompt or floppy drive B if you need to be set to the B drive.
Echo .
Echo To run the demo that is on the disk enter RUN_DEMO after you install
Echo DANCAD3D on your harddisk. There are other example MACRO files on the set of
Echo 14 disks that come with the manual. They include some that show you how to
Echo animate a robot, some mechanical simulations, and a macro that demonstrates
Echo DANCAD3D v2.x's ability to animate mathematical formulas.
Echo .
Echo Enter DANCAD3D to start the program. Press [T]utor from its main menu to
Echo read some help screens. Press [D]raw from the main menu to draw. When you
Echo run the program for the first time it will ask you for the video mode you want
Echo it to use. If you do not know what type of video board you have read the
Echo instruction book that came with your computer. Be sure and read the
Echo disclaimer in the file DANCAD3D.DOC before you try to use the program.
Echo .
Echo .
PAUSE
CLS
Type FILES.DOC
Echo .
Echo Enter RUN_DEMO to see the demo run. To run DANCAD3D when you turn your
Echo computer on again enter CD DC20 then enter DANCAD3D.