IDRIVERNAMEIPRIMARYIALTERNATEIRECVBUFSIRECVBUFSIZEIXMITBUFSIXMITBUFSIZEIRAMIPRODUCTIDINETADDRESSIMAXTRANSMITSIEARLYRELEASEIINTERRUPTIRAMSIZEIMMIOIRINGSPEEDIPROMPTIPCMCIAIADAPTERIENABLEBRIDGEIBRIDGERAMEA failure during initialization of the IBMTOKCS device
driver has occurred.
EAn unrecognized parameter %1 was found in PROTOCOL.INI.
EA value specified for a parameter in PROTOCOL.INI is not valid.
EA configuration error was found in PROTOCOL.INI.
EThe adapter is not responding or was not found.
EThe protocol manager could not be opened.
IInitialization starting for section %1 in PROTOCOL.INI.
EA lobe wire fault has been detected. The adapter will be closed.
EThere are not adequate receive buffers for the adapter to open.
IIBM Token-Ring adapter data rate is %1.
EAn invalid node address error occurred when the program attempted to open the adapter.
EThe receive buffer length defined is not valid. The adapter was not opened.
EThe adapter transmit buffer length defined is not valid. The adapter was not opened.
IIBM - IBM Token-Ring Network Driver, Version %1
EAn unexpected error caused the Open Adapter Command in the IBMTOK.OS2 device driver to fail. The open return code is %1.
EAn auto-removal error has been detected. The adapter will be closed.
EA remove MAC frame has been received. The adapter will be closed.
EAn open error occurred during the lobe media test phase.
EAn open error occurred during the physical insertion phase.
EAn open error occurred during the address verification phase.
EAn open error occurred during the roll call poll phase.
EAn open error occurred during the request parameter phase.
EThe open error type is Function failure.
EThe open error type is Signal loss.
EThe open error type is Timeout.
EThe open error type is Ring failure.
EThe open error type is Ring beaconing.
EThe open error type is Duplicate node address.
EThe open error type is Parameter request.
EThe open error type is REMOVE received.
EThe open error type is No monitor detected.
EThe open error type is Monitor contention failed for RPL.
EFor this micro-code level, the value specified for XMITBUFS in the file PROTOCOL.INI must be greater than 1. Run-time errors may occur if this value is not increased. IBMTOK.OS2 has defaulted this value to 2. See the help for this message for
further corrective action.
IWARNING! The entire ring will be disrupted if the Token-Ring adapter ring speed
does not match the speed of the existing ring.
IThe Token-Ring Credit card is ready to attach to the ring.
IIt is configured for a ring speed of %1 Mbps. Enter 'Y' if this is correct.
IIf you would like to change the configured ring speed to %1 Mbps,
Ienter 'C' for change.
IRing Speed configuration will REMAIN at %1 Mbps.
ICHANGING the ring speed configuration to %1 Mbps.