home *** CD-ROM | disk | FTP | other *** search
- echo off
-
- if exist hypgeo21.exe goto install
- if exist start.bat goto missing
- echo
- echo The START procedure must be run directly from the diskette drive
- echo or hard-disk directory in which it is located.
- echo
- echo For example, if you are installing HYPERGEO from a diskette
- echo in drive A, don't run A:START from a directory on another drive.
- echo Instead, you should first make the diskette drive the active drive
- echo and then run START, thus:
- echo
- echo A:
- echo START
- echo
- echo (If you're using the second diskette drive on your system,
- echo substitute B: for A: in the above directions.)
- goto done
-
- :install
- set d=%1
- if "%d%" == "" set d=C:\HYPERGEO
-
- echo
- echo The installation directory is: %d%
- echo
-
- hypgeo21 %d%
-
- if errorlevel 1 goto error
- if not exist %d%\hypergeo.hlp goto done
- echo
- echo The HYPERGEO program has been successfully installed.
- echo
- echo See the file README.1ST in the installation directory for an
- echo overview of the program and directions for trying it out.
- goto done
-
- :error
- echo
- echo An error occurred during the installation of HYPERGEO.
- echo
- echo Check to be sure that the drive and directory you are trying to
- echo install the program into were specified correctly and that there is
- echo sufficient free space on that device. The command
- echo
- echo DIR %d%
- echo
- echo will show you the amount of free space on the installation drive.
- echo (HYPERGEO needs about 800K bytes of disk space.)
- goto done
-
- :missing
- echo
- echo The START procedure can't find the file HYPGEO21.EXE. This file
- echo must be in the same directory as the START.BAT file itself.
-
- :done
-