home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
The Unsorted BBS Collection
/
thegreatunsorted.tar
/
thegreatunsorted
/
texts
/
cell_nfo
/
DATA
/
D_TEL01.TXT
< prev
next >
Wrap
Text File
|
1993-04-11
|
3KB
|
80 lines
DIAMONTEL MESA 50, 52, 52A, 55AX, 55BX.
NOTES: These are single NAM units.
The ESN prefix is 134 decimal, 86 hex.
See file MITSTEST.TXT for test mode access.
The MESA 50 will only accept handset programing if the software
version is L7.
All other models are capable of handset programing OR can have
a NAM chip burned. Handset programming is only possible if a NAM
chip is NOT installed.
DiamondTel: 708-298-9223
NAM programing:
1. Press PWR key for one second to turn on phone.
2. Wait for wake up cycle to end and display to clear.
3. Within ten seconds press and hold the CLR key while entering
8 2 9 1 1 1 2 (reset code).
4. Release CLR.
5. The phone will display the first data entry.
6. Press the SEND key to store information and increment the step number.
7. Press CLR to correct any item.
8. At any time press END to complete programing and exit.
PROGRAMING DATA:
STEP# #OF DIGITS/RANGE DISPLAY DESCRIPTION
01 10 DIGITS MUTE MIN (AREA CODE AND TEL#)
02 3 DIGITS 1 SECURITY CODE
03 00000 - 32767 2 SYSTEM ID
04 0 OR 1 3 LOCAL USE MARK
05 0 OR 1 4 MIN MARK
06 333 OR 334 5 INITIAL PAGING CHANNEL
07 2 DIGITS 6 ACCESS OVERLOAD
08 0 OR 1 7 PREFERRED SYSTEM
09 00 TO 15 8 GROUP ID (10 FOR USA)
10 0 or 1 9 CONTINUOUS DTMF
11 0 OR 1 10 HANDS FREE
12 0 OR 1 11 ROAM INHIBIT
13 00 TO 07 12 FUNCTION (SEE NOTE 1)
14 00 to 07 13 FUNCTION (SEE NOTE 2)
NOTES:
1. Enter one of the following to select these options:
2nd handset Non resettable timer Extended DTMF
00 = NO NO NO
01 = YES NO NO
02 = NO YES NO
03 = YES YES NO
04 = NO NO YES
05 = YES NO YES
06 = NO YES YES
07 = YES YES YES
2. Enter one of the following to set the timer increments:
00 = 60 seconds
01 = 30 seconds
02 = 20 seconds
03 = 15 seconds
04 = 12 seconds
05 = 10 seconds
06 = 6 seconds
07 = 1 seconds
LOCK: F 5. UNLOCK: Enter three digit code.
SYSTEM SELECT: F #, then # to select, CLR to store/exit.