Labels:text | aircraft | illustration OCR: SPITFIRE INSTRUCTIONS SPITFIRE INSTRUCTIONS 1. Print out the plane. 2. Cut out the parts. 3. You will see from the following sheet where to fold and glue the parts. You will also see the arrows showing where the tabs joins together. 4. First, make up the body. 5. Fold the top down and then glue the roof tab where shown. 6. Fold the sides up from the bottom and stick the roof together. 7. Glue the cockpit side tabs and stick them to the body. 8. Glue and stick the engine top to the sides where shown. 9. Glue the nose cone tabs and stick them to each other to form 9. a pyramid on its side. 10. Make the wings up by glueing the edge of the wing as shown but on the non printed side. 11. Starting at the tip of the wing, stick the opposite sides together. Don't make a crease where it folds over but leave it as a curve. Do the same with the central part of the wing. 12. Glue the underside of the body and stick the side tab to the side of the body. Stick the wings to the underside. 13. Fold the propellor into a pyramid shape. Glue and stick the pyramid to the nose of the body. 14. Fold the tail in hlaf, glue and stick together. 15. Slot the tail into the back of the body using the cut slits shown on the artwork. KEY . . Glue to Fold + Fold/slot under Glue position FZOL FZOL O O
(.png)
