home *** CD-ROM | disk | FTP | other *** search
- --------------------------------------------------------------------------
- Setup hints for using BGFAX, PC Board 15.22, US Robotics Modems 11-05-95
- B.J. Guillot
- FidoNet 1:106/400 InterNet: bjg90783@jetson.uh.edu
- --------------------------------------------------------------------------
-
- NOTE: US Robotics owners, please read over the USR section in the READ.ME
- file before proceeding!
-
- Please make sure the following three items are true before proceeding...
- (1) Your modem is NOT set to "Auto Answer" mode (REGISTER S0 MUST EQUAL 0)
- (2) DIP switch #5 is in the "SUPPRESS AUTO ANSWER" position
- (3) You have already put all relevant DATA commands for the BBS into NVRAM
-
- Note that, generally, fax (AT+F) commands CANNOT be stored in NVRAM.
-
- Run PCBSETUP.EXE and make the following changes in the modem section...
- (Do not use PCBMODEM.)
-
- Make the following changes...
-
- Init-1 ATZ^M~~AT+FCLASS=2.0
- Init-2 AT+FNR=1,1,1,1;+FLI="713 555 1212"
- Offhook ATH1M0
- Answer AT+FAA=1;A
- Dialout AT+FCLASS=0DT
-
- If your BOARD.BAT file (or, whatever the file is that starts up your BBS),
- after the PCB.EXE line...
-
- pcb.exe
- if errorlevel 7 rcvfax.bat
-
- (If you have any other "if errorlevel" lines in your BOARD.BAT, remember
- that errorlevel numbers must be in DESCENDING order: 9,8,7,6,5, etc.)
-
- Make a new file called RCVFAX.BAT that says the following:
- @echo off
- bgfax /fco:4 c:\bgfax 1 z
- board.bat
-
- The "1" is for COM1. Change that if necessary for your modem.
-
- P.S... USR's FAX/ARQ light WILL flash when waiting for calls!
-
- Regards,
- bgfax author
-