home *** CD-ROM | disk | FTP | other *** search
- Welcome to MIDI Station Sequencer
-
- Introduction
-
- MIDI Station Sequencer uses the RTMIDI subsystem for its playback and recording of
- sequences. Therefore you MUST have a RTMIDI compatable soundcard/driver in order
- to use this program. If you do not please read the accompanying MSTATSEQ.HLP file under
- System Requirements - Setting up your soundcard for information on how to get your system
- RTMIDI compatable.
-
- This program also uses the new high-resolution timer so there are a few things that you
- should be aware of:
-
- 1) When using this program you should not use any Windows and/or DOS programs
- 2) The minimum configuration that will give back acceptable performance is a
- 486 DX/4 100 MHz. Any system will work but your results may not be acceptable.
-
- Installing the program:
-
- 1) Unzip this file into a directory
- (Obviously you've already done that since you're reading this!)
- 2) Type install
- 3) You will be prompted to enter a path where the program will reside
- 4) The installation routine will create a folder and program objects for you.
-
-
- Troubleshooting and Technical Issues
-
- If you need help getting your system to be RTMIDI compatable, please READ the included
- MSTATSEQ.INF file. It contains many suggestions and ways of getting your system ready.
- If after doing this nothing works - send me some email at: cdhodge@ibm.net. I've probably
- encountered the same problem and can help you with it. Also take a look at my website -
- it has the most current configuration/setup problems and directions.
-
-
- Enjoy!!!
-
-
- Christopher Hodges
- Author of MIDI Station and MIDI Station Sequencer
- cdhodge@ibm.net
- WebSite: http://www.geocities.com/SiliconValley/Horizon/6780
-