Labels:bulletin board | dialog box | earth | element of a cylinder | monitor | reckoner | sky | window OCR: 11 Inspect and resolder the foil side of the PLI board under vCo 5 12 Install the vCo shield on the PLL board and solder place 13 Seal the vco with hot melt glue qlue used hot melt glue gun) Apply the qlue to the circuit from the glue qun Once the area is covered use the hot air gun to flow the glue around the components. Do not overheat the components 14 Install the PLL board the transceiver. 15 Apply power to the transceiver and allow it to run in receive for about hal hour 50 the transceiver' temperature stabilizes 16 Set the operating frequency 200MHZ Adjust T20 to obtain 5VDC at TP11 (the exposed lead of L40 measured with DVM or VTVM Do not use WOM After adjusting the vco bench run the transce ver for an hour more make sure the circuit is stable 18. Assemble the transceiver, 1C9 IC4 I ...
.iso/mods/kenwood/servbull/asb0973b.jpg){kind=small}
.iso/mods/kenwood/servbull/asb0973a.jpg){kind=link}
.iso/mods/kenwood/servbull/asb0974a.jpg){kind=link}