Labels:book | bulletin board | lodestone | poster | reckoner | sky OCR: 22 Locate R105. If the component is 47K ohm change it to 7K ohm chip resistor The component value can be determined by the numbers written on the case If the device labeled 473 ohm resistor and needs to be repl laced the devi ice label lec ohm resistor and does not need to be repl aced gure 23 stra ighten the tabs that hold the LCD assembly to the Control board. Care fully pull the LCD assembly off the Control board (do not break the flex cable Fiqure 24 Remove C123 This chip capaci itor is located in the corner of the board under the LCD assembly Figure 25 Remove the protective coating from the foils as shown in Piqure 11 place the OV zener diode on the board Size and cut the diode's cathode lead Solder the lead to the board rigure 2 Place the IK ohm res istor on the board The body of the ...
.iso/mods/kenwood/servbull/asb0972c.jpg){kind=small}
.iso/mods/kenwood/servbull/asb0972b.jpg){kind=link}
.iso/mods/kenwood/servbull/asb0972d.jpg){kind=link}