Labels:book | bulletin board | lodestone | poster | reckoner | sky OCR: Remove three brass colored screws from Control board B/3. Figure Remove the brass col lored screw that mounted the front panel chassis above the Power swi tch Pigure Remove the brass colored screw that mounted the front panel chassis to the right of the m crophone jack Figure 10 Carefully pull Control board B/ from the body transce iver 11 Disconnect the two "wire type" cables from the body of the transce iver Disconnect the two flex cables from the Control board. The flex cables simply pull out the connectors 13 Remove IC102 from the Control board since this devi ice is glued to the board use needle tool to lift each pin ae you melt the solder Then pry the chip the board with craft knife Fiqure 1.4 Remove any excess glue and solder from the area where IC102 was located 1F Remove chip resi ...
.iso/mods/kenwood/servbull/asb0972b.jpg){kind=small}
.iso/mods/kenwood/servbull/asb0972a.jpg){kind=link}
.iso/mods/kenwood/servbull/asb0972c.jpg){kind=link}