home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
World of Ham Radio 1997
/
WOHR97_AmSoft_(1997-02-01).iso
/
mods
/
icom
/
icu16_1.doc
< prev
next >
Wrap
Internet Message Format
|
1997-02-01
|
3KB
From: rosenblg@cmcl2.nyu.edu (Gary J. Rosenblum)
Subject: how to program the ICOM-U16
-------------------------------------------------------------------------
If the U16 has been made programmable by moving a jumper:
Try holding FUNCT down and entering 159357.
It's now in prog mode. Exit with FUNCT-CLR.
Function + 159357 (Enter program mode)
Function + 1 Encoder tones (1-37) 1=67.0,2=71.9,3=74.4,4=77.0,5=79.7,
6=82.5,7=85.4,8=88.5,9=91.5,10=94.8,
11=100.0,12=103.5,13=107.2,14=110.9,
15=114.8,16=118.8,17=123.0,18=127.3,
19=131.6,20=136.5,21=141.3,22=146.2,
23=151.4,24=156.7,25=162.2,26=167.9,
27=173.8,28=179.9,29=186.2,30=192.8?,
31=203.5,32=210.7,33=218.1,34=225.7,
35=233.6,36=241.8,37=250.3
+ 2 Decoder tones (1-37)
+ 3 ?
+ 4 Delta + / Delta - offset, 5 digits
+ 5 Frequency, 5 digits (400MHz +)
+ 6 ?
+ 7 Sch. Ch. numbers. Allows alias ch numbers.
+ 8 Transmit timeout enable.
+ 9 TI, Transmit Inhibit
+ SCAN Priority Scan/Ch Scan
+ S.CH Channel Masking
+ CLEAR End progamming mode
---------------------------------------------------------------------------
Channel select: Standard method (up/down arrows or CH# + [ENTER])
Frequency: Hold [FUNC], Press [5], enter 6 dig freq, [ENTER], release
[FUNC]
Rx CTCSS: Hold [FUNC], Press [2], enter 2 dig code, [ENTER], release
[FUNC]
Tx CTCSS: Hold [FUNC], Press [1], enter 2 dig code, [ENTER], release
[FUNC]
Offset Freq: Hold [FUNC], Press [4], use [#] for up offset, [*] for
down offset, then enter freq to offset by (ie: [#] [0] [0]
[0] [0] [0] for no offset, [#] [0] [5] [0] [0] [0] for the
standard +5MHz UHF offset), [ENTER]
Timeout Timer: Hold [FUNC], [8], Release [FUNC]
Tx Inhibit: Hold [FUNC], [9], Release [FUNC]
Special Channel Number: Hold [FUNC], Press [7], enter the special
channel number (17-99), [ENTER], Release [FUNC]l
Data Transfer MASTER: Hold [FUNC], [BEEP], Release [FUNC]
Data Transfer SLAVE: Hold [FUNC] with power off, turn on, release
[FUNC]