To install Europe 1 and/or Europe 2 run SETUP.EXE.
If you follow thses instructions, you can enjoy your EUROPE1 and EUROPE2 scenery again under FS95:
If you have previously installed Europe 1 or Europe 2 for FS95 manually,
you must delete the scenery you are going to install with this setup program
from the Scenery Areas menu (World-Scenery Library-Files) in FS95.
Please note that Europe 2 must have a higher priority (lower layer number)
than Europe 1. If you first install Europe 1 and then Europe 2, you don't have
to make any changes to the priority level.
Europe 1.
--------
The setup program upgrades older versions of Europe 1 to version 1.02a.
It also fixes the ILS localizer heading at Dresden, Germany.
The setup program also fixes the frame rate drop problem near the
border of Europe 1 and Europe 2 that FS95 causes.
If you receive an error message during the setup procedure CAN NOT CREATE TEMPORARY DIRECTORY E1E2TEMP, then please remove that temporary directory E1E2TEMP manually first and restart the installation. This directory might still be there from an earlier installation that has been aborted.
You should also deinstall via the FS95 SCENERY LIBRARY MANAGER any references to EUROPE1 or EUROPE2 that you might have installed or previously copied manually.
Europe 2.
--------
The setup program fixes some problems regarding the dynamic scenery.
Known problems Europe 1 & 2 with Microsoft Flight Simulator for Windows 95.
FEPAT.EXE, copyright Microsoft. Enables the missing ILS back into FS95. Please run after applying the E1E2FS95 installation and before starting FS95. This will then make the necessary changes to FS95.