home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Chip 1997 April (Special)
/
Chip-Special_1997-04_cd.bin
/
ati
/
64w31201
/
readme.txt
< prev
Wrap
Text File
|
1995-12-14
|
2KB
|
60 lines
mach64, 64W31201.ZIP
*****************************
1.0 Introduction
2.0 Installation Notes
*****************************
1.0 Introduction
The mach64 device drivers supplied here are for Windows 3.1 and
Windows 3.11. THIS ZIP FILE CONTAINS WINDOWS 3.1X DISPLAY DRIVER
FILES ONLY.
*****************************
2.0 Installation Notes
IF YOU HAVE NOT INSTALLED A mach64 WINDOWS DRIVER PREVIOUSLY, YOU MAY
REQUIRE YOUR MICROSOFT WINDOWS DISKETTES TO COMPLETE THE INSTALLATION
OF THIS DRIVER.
1. Ensure that you have a copy LOAD64.ZIP. It is available on the ATI
BBS, ftp site (ftp.atitech.ca), and on our CompuServe forum (GO
ATITECH).
2. Ensure that you have a copy of PKUNZIP.EXE, v1.10 or later.
PKUNZIP is available on most BBS and information services, including
the ATI BBS and CompuServe.
3. Do NOT attempt to perform the driver installation from within
Windows Exit Windows completely, and perform the following operations
in DOS.
4. Unzip LOAD64.ZIP and 64W31201.ZIP into the same temporary directory
on your hard disk, then run the LOAD64.EXE utility. For example:
MD \ATITEMP
PKUNZIP LOAD64.ZIP \ATITEMP
PKUNZIP 64W31201.ZIP \ATITEMP
CD \ATITEMP
LOAD64.EXE
5. Follow the screen prompts for installing the Windows3.1 driver.
IF YOU RECEIVE AN ERROR MESSAGE, INDICATING THAT A CERTAIN FONT (.fon)
FILE IS NOT PRESENT, YOU WILL NEED TO RUN WINDOWS SETUP FROM DOS TO
COMPLETE THE INSTALLATION. WINDOWS SETUP WILL PROMPT YOU FOR THE
DISKS ON WHICH THESE FONT FILES ARE FOUND.
6. Once the driver has been installed, you can delete the contents of
the temporary directory (DEL \ATITEMP\*.*) and delete the directory
itself (RD \ATITEMP).
7. We recommend that you keep a copy of the ZIP files (64W31201.ZIP
and LOAD64.ZIP), in case you need to install the driver again.
*****************************