If you are going to upgrade BIOS from BIOS version 1002.A (and earlier) for CUSL2-M, please make sure the following item in the BIOS setup menu is set at [PCI/AGP] before updating the BIOS with v1.27 flash tool.
In case the system is unable to start up properly after performing BIOS upgrade, please remove all the add-on VGA adapters from the system and start up the system with the onboard AGP graphics controller or clear CMOS. The add-on VGA adapters then can be installed after loading the setup default from the BIOS setup menu.
Aflash.exe
CUSL2-M BIOS Flash Tool v1.27 08/28/2000
Solve using previous flash tool would not boot up.
Cusm1008.zip
CUSL2-M BIOS Ver. 1008 08/14/2001
Support Mediatek 4(+2)-channel CNR audio card with onboard AD1881A codec enabled.
Fix USB modems cannot work after system resumes from Suspend-to-RAM (S3) state under WinME or Win98SE.
Fix the reading of "JTPWR Temperature" hardware monitor setup item updates slowly.
Fix HDD Keeper PCI card shows "Divide Error" message on the screen and caused system to halt during boot up.
Fix false alarm from hardware monitor during POST.
Fix Logitech MouseMan PS/2 mouse cannot wake up system from Suspend-to-RAM (S3) state, hibernate (S4) state and soft-off (S5) state by clicking under Windows 2000.
Fix system enters Suspend state later than the period specified by the option of "Suspend Mode" setup item under MS-DOS.
Fix iPanel sometimes shows incorrect CPU temperature reading.
Add "iPanel Update Timer" setup item.
Turn off PS/2 keyboard LEDs before system enters soft-off state.
Correct DMI CPU voltage information.
Correct DMI ROM size information.
Fix CPU fan not turned on immediately after system resumes from Standby (S1) state if Intel ATA-100 driver has been installed.
