home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Columbia Kermit
/
kermit.zip
/
archives
/
k10mit-135.tar.gz
/
k10mit-135.tar
/
k10mit-135
/
k10133.mem
< prev
next >
Wrap
Text File
|
2001-06-19
|
3KB
|
71 lines
Kermit-10 now has a lot of patches put into it. The first set of
patches is based on those submitted by PIMA. The subsequent patches
are added in order to make Kermit-10 similar to Kermit-32. The last
patch is to change all the search file names to K10??? as opposed to
KER???.
1.0
PATCH [127]
Based on the patches we received from PIMA the following changes
have been added to KERMIT and KERUNV.
1. Fix IFN stopcode if syntax error in KERMIT.INI.
2. Add help text for connect mode ESCape commands. Q (Quit) and
R (Resume) logging
3. Add SET XON-XOFF-PROCESSING to determine how Xon/Xoff should
be handled during connect.
4. Add a new File Byte Size of 36-Bits for 10/20 transfers
These changes are in Modules KERMIT and KERUNV
Page 2
2.0
PATCH [130] & [3.1.045]
When attempting to do multiple file sends from Kermit-10, the
prompt indicating subsequent sends is screwed up. It sends: the sent
file name, followed by, "as ", "Sending: ", and then, the original
file name. This is due to the timing of when NEXT_FILE prints the
"Sending: " prompt. The fix is to take the subsequent file sending
prompt out of KERMSG and put it into KERMIT. This fixes the problem,
but it also requires a similar patch to be put into KERMIT-32 and
PROKERMIT.
Changes were to Modules KERMIT and KERMSG.
3.0
PATCH [131], [132], & [133]
Make KERMIT-10 look similar to KERMIT-32. Alow KERMIT to set the
IBM handshaking character, incase the IBM character is something other
than ^Q. Fix the IBM macro defined to set up the three parameters
required for IBM transfers, this means to add in the setting of the
handshake character. The kludge use of IBM-MODE is no longer needed,
remove it.
The changes are in Module KERMIT
Page 3
4.0
PATCH [134]
Since the distribution files for KERMIT-10 are changed to
K10???.???, lets make the source file names that in the first place.
This requires that all search file names must be changed to K10???.
The prologue in K10UNV should remain as KERMIT or else you won't be
able to find the help file for KERMIT. Also there is a new help file
which contains the SET HANDSHAKE and SET XON-XOFF-PROCESSING help.
The help file also modifies the the SET IBM-MODE command to SET IBM
which initiates the IBM macro.
These changes were done to ALL Modules.