Please note, that the applications you want to install SPEA drivers for have to be already completely installed (for Standard VGA (640 x 480, 16 colors) on your system prior to using the SPEA software. It is a good idea to do this before removing an existing graphics adapter as not every application permits the configuration of the video mode used from the DOS plane.
Changing your PC's BIOS SETUP
If a board other than a VGA board was previously installed, it is necessary to change the PC's hardware configuration. This is sometimes done by changing a jumper on the motherboard after removing the old board (check your motherboard or PC manual) although it more common to change your PC's BIOS SETUP.
Exception:
If you have a system with a EGA/VGA display adapter built onto the motherboard. In this case, the on-board EGA/VGA display adapter must be disabled before installing the SPEA card.
Please check your PC manual to find the location of the corresponding switch.
Warning
Simultaneously using two active VGA/EGA units in one PC will inevitably lead to system failure!
If your system doesn't have to be re-jumpered for a VGA board then first proceed with the following installation steps and then run your BIOS SETUP program and select 'VGA' (else 'IBM VGA') as your graphics board type. Check your PC manual for information on its BIOS SETUP.
1. Switch off your computer and all peripheral devices (printer, display, and others).
2. If it is necessary to disconnect peripheral equipment cables from the back of the computer, be sure to note cable positions for proper reconnection later.
3. Remove the cover from your computer. Save the mounting screws for reinstalling the cover.
