home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Internet Standards
/
CD2.mdf
/
ccitt
/
1992
/
k
/
k23.asc
< prev
next >
Wrap
Text File
|
1993-06-28
|
2KB
|
247 lines
Recommendation K.23
TYPES OF INDUCED NOISE AND DESCRIPTION OF NOISE
VOLTAGE PARAMETERS FOR ISDN BASIC USER NETWORKS
1. Purpose of this Recommendation
This Recommendation has been produced by CCITT Study Group V to meet the urgent requirements
of administrations, manufacturers, and users who should evaluate equipment for its immunity to induced
noise in order to design and use the ISDN.
This Recommendation identifies the types of induced noise that can cause degradation of transmis-
sion quality and malfunction of the equipment, and noise voltage parameters that should be evaluated.
2. Scope
This Recommendation covers the degradation of equipment performance due to induced noise volt-
age, which is caused by an inducing source external to the cable, or by another telecommunication sys-
tem, on metallic pair cables (including residential inside wire). However, this Recommendation does not
cover interference caused by transmission characteristics of cables (for example, cross talk characteris-
tics).
This Recommendation considers the characteristics of induced noise voltages at metallic-pair ISDN
interfaces at subscriber's premises. Interface locations covered by this Recommendation are the S and T
interfaces (see Recommendation I.430) as well as the two wire interface of the NT1.
The communication line constituting the S/T Bus may be confined to a building, or connect two sepa-
rate buildings. The connecting telecommunications line may be either aerial or below-ground.
3. Types of induced noise affecting the ISDN
3.1 Mode of voltage
Two voltage modes should be considered: longitudinal voltage and transverse voltage. Figure 1 illus-
trates the definition of longitudinal voltage induced in telecommunication lines and the transverse voltage.