home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
DP Tool Club 8
/
CDASC08.ISO
/
VRAC
/
DMDTRV30.ZIP
/
ERROR.QB
< prev
next >
Wrap
Text File
|
1993-08-14
|
2KB
|
46 lines
QuickBasic Error codes
DoorFrame uses the QB error codes.
---------------------------------------------------------------------------
2 Syntax Error 61 Disk full
5 Ilegal Function Call 62 Input past end of File
6 Overflow 63 Bad record number
7 Out of memory 64 Bad filename
11 Division by Zero 67 Too many files
13 type mismatch 68 Device unavailable
24 Device Timeout 69 Comm-buffer overflow
25 Device fault 70 Permission denied
52 Bad filename or number 71 Disk not ready
53 File Not Found 72 Disk media error
55 File Already open 74 Rename across disk
57 Device I/O error 75 Path/File access error
58 File already exists 76 Path not found
59 Bad Record length
The most common error that you will see is #62. This is usually caused
by the CFG file not having enough lines. I have included this list so
that you may be able to fix a problem that occurs with a PAROLE Software
door.
Error #75 is usually an incorrect path and/or filename in the CFG file.
If you are operating on a 486 computer and getting a "keyboard timeout",
you will need to set the following environment variable in your
autoexec.bat.
SET NO87=ON
This will turn off your co-processor and allow the door to function
properly. If you are operating under DESQview/X, you must flag the MATH
COPROCESSOR as being ON.
If the door seems to operate fine on the BBS end but the remote cannot
receive or receives garbled info, check and make sure you are pasing the
correct IRQ to the door. Com 1 and 2 are standard and as such you do
not need to pass the IRQ to them.
If you are operating under DESQview, you will need to load DVANSI in
each window.