[<<Previous Entry]
[^^Up^^]
[Next Entry>>]
[Menu]
[About The Guide]
Volume VOLNAMES have been completely shut down due to channel failure.
Occurs on: SFT I, SFT II, TTS.
Meaning: The disk channel on which the disk volumes named
VOLNAMES are located was shut down because NetWare
detected a fatal error on the channel. NetWare
detected the failure by timing out or by receiving an
invalid interrupt from the Disk Coprocessor board.
This is not a fatal error as long as volume SYS is not
affected. Any remaining channels containing volumes
may continue to operate. If volume SYS is shut down
then the system will halt.
Cause: This error could be caused by faulty connections or by a
faulty Disk Coprocessor board, controller, or disk drive.
Solution: Make sure that the Disk Coprocessor board is properly
seated and the connections to the controllers and
drives are tight and have not become loose or broken.
Next, swap components with known good ones until the
problem is found. Start with the Disk Coprocessor
board and then exchange the controllers and drives.
This page created by ng2html v1.05, the Norton guide to HTML conversion utility.
Written by Dave Pearson