home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
ftp.wwiv.com
/
ftp.wwiv.com.zip
/
ftp.wwiv.com
/
pub
/
MISC
/
TOURIST.ZIP
/
TOURIST.CNF
< prev
next >
Wrap
Text File
|
1995-01-04
|
3KB
|
50 lines
C:\GAP
The Crow's Nest BBS
4
03F8
STANDARD
D000
320
4
**************************************************************************
Explanation of the above parameters
Line 1 - Full Path to the BBS Default Directory (where DOOR.SYS is)
Line 2 - Name of the BBS
Line 3 - IRQ for this Port. If running COM ports other than 1 or 2
this must be the IRQ that will be used for that Port. If
running on COM 1 or COM 2 or using a DigiBoard, this can
be set to 0.
Line 4 - Base Address for this Port (In Hex). If running ports other
than 1 or 2 this must be the Base Address that will be used
for that Port. If running on COM 1 or COM 2 or using a
DigiBoard, this can be set to 0.
Line 5 - The COM Port Interface to use:
STANDARD = Regular Communications Port Interface. This
is what you would normally use.
DIGIBOARD = Direct DigiBoard Programming Interface. Must
be used in conjunction with a program called
RESETDIG.EXE. If you don't have this program
but have a DigiBoard, then use the following
option.
INT14/EBIOS = Indirect DigiBoard Support via a Device Driver.
All Communications to the DigiBoard (or any
board that supports INT14/EBIOS) are performed
via a Software Interrupt that the Device Driver
handles.
Line 6 - If using a DigiBoard, this is the Memory Window, or the
address the card uses as a communications area between
the card and the Host Computer. Only needed if using
an Interface set to DIGIBOARD. If using STANDARD or
INT14/EBIOS, can be set to 0.
Line 7 - If using a DigiBoard, this is the I/O Port address that
the Board is attached to. Only needed if using an
Interface set to DIGIBOARD. If using STANDARD or
INT14/EBIOS, can be set to 0.
Line 8 - If using a DigiBoard, this is the Channel Number for
this port on the Digi. This is REQUIRED for DIGIBOARD
and INT14/EBIOS Interfaces. This is 1 - 8 for the
DIGIBOARD Interface and usually 4 - 11 for the INT14/EBIOS
Interface. This number tells the program which of the
Com Ports on the DigiBoard it should use.