home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Network Support Encyclopedia 96-1
/
novell-nsepro-1996-1-cd2.iso
/
download
/
netware
/
drvkit.exe
/
DISKDRV
/
OLIVETTI
/
OLIESC1.TXT
< prev
Wrap
Text File
|
1990-09-25
|
3KB
|
96 lines
README
Contents :
File Name Size in Bytes Date Stamp Time Stamp
OLIESC1.DSK 6889 08-29-90 9:42a
This floppy contains the NetWare 386 SCSI driver for the Olivetti
EISA SCSI Controller (ESC-1).
For information about installation of the EISA SCSI Controller ESC-1,
refer in the "Installation and Operation Guide" for your system.
The driver is named OLIESC1.DSK and is installed as a loadable disk
driver module.
The SCSI driver should be used to meet the following requirements:
1) For increased fixed disk performance
2) To support more than 2 disks. The ISADISK.DSK supports 2 disks
only.The OLIESC1.DSK supports 2 ESC-1's with 7 SCSI disks per
controller.
3) To support disk duplexing with the ESC-1 ( 2 controllers with
drive mirroring).
4) To support 2 ESC- 1 controllers installed in the system for
optimum disk performance.
To install this driver follow the process detailed in the Novell
NetWare 386 Installation Guide, in the file server section.
The SCSI driver will have to be manually copied to :
A. Your server boot diskette - or
B. The server subdirectory in the DOS partition
This is covered in detail in the NetWare manual.
To load the driver you should enter the following command at the
" : " prompt:
load <pathname>OLIESC1 <SLOT=n>
where n is the slot number.
Interrupts and I/O address are determined automatically.
After loading, Driver version information is obtainable with the
command :
modules
or with the monitor utility described in NetWare 386 manual.
Suggested SETUP procedure for EISA 486 machines, running NetWare 3.x
A. Install 1 or 2 ESC-1 in slots 1-6, wich support Bus Master
B. Run the Eisa configuration Utility to configure the ESC-1(s)
The configuration should look as follows:
Hard Disk Controller
AT Compatible Disk Controller Disabled
SCSI ID Selection
Drive 0 : 00
Drive 1 : 01
ROM BIOS Access Mode Full SCSI (1)
Direct SCSI Enabled
Notes :
(1) This is the suggested configuration running NetWare.
However,if you want to run applications in the DOS environment,
prior to or after NetWare, the suggested value is:
AT Compatible.
For Customer support and instruction on how to receive future updates
for this driver, conctact:
Olivetti Systems & Networks
via Jervis 77
10015 Ivrea TO Italy
Tel: +39 125 525