The time-out value determines how long the plotter can instruct AutoCAD LT to stop sending data while it empties its buffer. After the plotter empties its buffer, it accepts more data from AutoCAD LT. If the plotter pause is longer than the time-out setting, the following message is displayed.
An error has occurred while writing to the hardcopy device. Please check that it is turned on, online, and has paper. Abort? <N>
When you configure your plotter and are prompted for a time-out value, specify how much time you want to elapse before AutoCAD LT displays an error message for you to cancel the plot.
If your drawings are complex or your pen speed is very slow, set the time-out value higher than the default (30 seconds).
If you begin to receive numerous time-out prompts, your time-out setting is probably too low.
You can set the time-out value during initial configuration or during configuration at plot time.