You can create multiple copies of objects as you modify them with any of the grip modes. For example, by using the Copy option, you can rotate the selected objects, leaving copies at each location you specify with the pointing device.
You can also make multiple copies by pressing SHIFT as you select the first point. For example, with the Stretch grip mode, you can stretch the object, such as a line, and copy it to any point in the graphics area. AutoCAD LT continues to make multiple copies until you turn off grips.
You can place multiple copies at regularly spaced intervals with an offset snap. The offset snap is defined by the distance between an object and the next copy. In the lighting layout below, the first copy of the light fixture symbol is placed at an offset of two units. All subsequent copies are then placed two units apart.
If you hold down SHIFT while you select multiple copy points with the pointing device, the graphics cursor snaps to an offset point based on the last two points you selected. In the illustration below, the midpoint of line 1 is at coordinates 8,5. Based on that midpoint, line 2 was copied using the SHIFT key and Stretch grip mode; its midpoint is at 9,5. The third line snaps to an offset based on the coordinate values, 10,5.
Similarly, you can place multiple copies at angular intervals around a base grip with a rotation snap. The rotation snap is defined as the angle between an object and the next copy when you are using Rotate grip mode. Hold down SHIFT to use the rotation snap.