|
Draw toolbar:
|
|
Draw menu: Arc |
|
Command line: arc |
Center / Start point: Specify a point, enter C, or press ENTER to start tangent to last line, arc, or polyline
Specifies the center of the circle of which the arc is a part.
Center: Specify a point
Start point: Specify a point
Angle / End point: Specify a point or enter
an option
Draws an arc counterclockwise from the start point (2) using the center point (1) and a specified included angle. If the angle is negative, AutoCAD LT draws a clockwise arc.
Included angle: Specify an angle
Using the center point (1), draws an arc counterclockwise from the start point (2) to a point that falls on an imaginary ray drawn from the center point through an endpoint (3).
Specifies the starting point of an arc.
Center / End / <Second point>: Specify a point or enter an option
Specifies the center of the circle of which the arc is a part.
Center: Specify a point (2)
Angle / End point: Specify a point or enter an option
Included angle: Specify an angle
As shown in the illustration, the arc does not necessarily pass through the point you specify to define the ray.
Specifies the endpoint of the arc.
End point: Specify a point
Included angle: Specify an angle
Draws an arc using three specified points on the arc's circumference. The first point is the start point (1) and the third is the endpoint (3) of the arc. The second point (2) is a point on the circumference of the arc.
End point: Specify a point (3)
You can specify a three-point arc either clockwise or counterclockwise.
Draws an arc tangent to the last line, arc, or polyline drawn when you press ENTER at the Center/Start Point prompt.
End point: Specify a point (1)
