Serial Connection Settings

The serial protocol is used to connect to another computer with your computer's COM port or a modem attached to your computer's COM port.

Note: The serial protocol is only available if selected when CRT is installed.

Port

The serial port (COM1, COM2, etc.) used by the session.

Baud rate

Select the Baud rate for the device. The default value is 38400.

Data bits

The number of communication Data bits. The default value is 8.

Parity

Choose the Parity setting supported by the connected device. The default setting is None.

Stop bits

The number of stop bits sent after each character. The default value is 1.

Flow Control Settings

DTR/DSR

Select this option to use the DTR/DSR (data-terminal-ready/data-set-ready) signals with the connected device. By default, this is NOT selected.

RTS/CTS

Use RTS/CTS (request-to-send/clear-to-send) hardware flow control. By default, this option IS selected.

XON/XOFF

Use XON/XOFF software flow control. By default, this option is NOT selected.