PRINT allows you to send the part currently displayed on
the screen to the printing device previously assigned in
the CONFIG program.

To get the desired line type and line width in your 
printed part, review the following guidelines:

* Width assignment is directly associated with the pen
  stroke. For example, a pen width assignment of three 
  equals three pen strokes when plotted or three dots 
  when printed.

* If you want to get the same exact width results on paper
  that are displayed on the screen, use rectangular filled
  polygons.

* Set the desired pen width in SETUP before dumping the
  part.

* The startpoint and endpoint of a line type other than
  solid always end in a full segment (complete dash).
