 HSECT                                                       Menu: (DRAW) EWIRE
 ==============================================================================
 Hatches the section planes of walls or polygons.

         1.   (NUM) set hatch on: 1-sectioned walls, 2-sectioned polygons
         2. * (NUM) hatch angle (relative to X-axis, 0-360)
         3. * (NUM) hatch interval (greater than 0)
         4. * (NUM) shift hatch (greater than 0)

 Description:
 This command creates a hatch pattern on planes that have been sectioned. After
 sectioning a model in the solid module, save a two-dimensional projection of
 the model (by using the command \save). Return to the geometric module and
 load the two-dimensional file.
 When you call this command you will be asked whether you wish to hatch the
 section plane of walls or polygons. You are then prompted for the hatch angle
 relative to the X axis, the hatch interval, i.e., spacing between parallel
 lines of the hatch and the shift distance.
 You may hatch the section plane repeatedly, varying the angle, the spacing and
 the shift, thus creating complex patterns.
 Hatch-lines slow down the redrawing of the model, so they will only be redrawn
 upon request via the \refh command.
 Hatched areas are regarded as polygons. You may not select an individual
 hatch-line (e.g., for updating its color). A hatched area may be broken into
 several hatched entities if the number of lines within it exceeds a given
 limit.
