Documentation Printer›             by Ron Fetzer››      Have  you  ever  tried  to print› documentation that looks good on  the› screen  in  40 column format but is a› mess when you print it out. The  text› is  all on the left side of the paper› and it is printed  as  one  continous› section.  When   you   separate   the› sheets,  sometimes  half a line is on› each sheet. Even worse at times there› are  no  provisions made for printing› the documentation at all.››      This short  program  will  print› any  documentation   file   that   is› printed    to    a    disk   with   a› wordprocessor. It will put in top and› bottom  margins  and page numbers. It› will center the 40 column text so  it› is in the middle of the page. It will› work on any printer.››       You   can   also    read    any› documentation  on  the  screen.  When› viewing  a  documentation  the screen› shows you about 18 lines of  text  at› one  time.  To  scroll  to  the  next› screen  you   press  any  key. In the› screen mode  the  program  opens  the› file  in  line  240.  In  line 250 it› counts how many times the  buffer  is› accessed.  If  is is 18 times then it› goes to the scroll  routine  in  line› 470.››      The print section starts on line› 350. It counts  how  many  times  the› print buffer is accessed. If it is 57› then it goes  to  the  page  printing› routine in line 490 and prints a page› number. The program  has  no  printer› control  codes  so  it will work with› any printer.››      Most documentation files have an› extender  of  'DOC'  or  'TXT'.   The› program    cannot   read   a   normal› wordprocessor file. If  you  want  to› make  this a selfbooting program then› save it with the filename 'MENU'  and› copy  the 'AUTORUN.SYS' file from any› Antic Monthly Disk.›      Please hit  the  RESET  key  and› type in RUN "D:DOCPRINT.BAS"›› >>>>>>>>>>>>>>>>END<<<<<<<<<<<<<<<<<<›››