Miracom HST-DS


    DipSwitches: 1-2-4-6-7-10 up.
    FroDo config-1: ATEQB1C1M1V1&A2&B1&C1&H1&I0&K1&M4&N0|
    FroDo config-2: AT&Y1S10=10S11=70S15=72S28=9S9=4S2=64H|
    Dial prefix: ATS7=60DT (OR P if Pulse Dialling)
    Dial suffix: X2|
    Answer: ATS7=26BA|
    Lock port: Yes
    Max baud: 38400
    Reset to connect speed: No
    Lower DTR when busy: No
    Lower DTR to terminate: Yes
    Toggle DTR before dialling: Yes

    Delay between sending characters: 2

    I use @@@ as an 'escape' character sequence hence the S2=64... this may
    confuse people so maybe it would be better to use

      FroDo config-2: AT&Y1S10=10S11=70S15=72S28=9S9=4S2=43H|

    which is the default...  those settings work great with FroDo etc.. inside RA
    theres only the one space for modem init :-( so I rely on the modem being
    configured with the above in nvram (i dont like to use nvram too much incase it
    gets corrupted), and heres what works in ra:

      init: atz|athms0=0m1qs7=26b|
      onhook: ath1|
      answer: ata|

    it may not be the best but it works here and usually gives great throughput :-)

    The above Courtesy of Stuart Henderson 2:255/13

    Valid on 4th February 1991
    Copyright John Barton RemoteAccess Support Europe HQ 2:257/168