[<<Previous Entry]
[^^Up^^]
[Next Entry>>]
[Menu]
[About The Guide]
The RemoteAccess Event Editor allows you to set pre-
determined times during the week when RemoteAccess will
automatically exit to your batch file and perform certain
functions, usually some kind of system maintenance. Select
EVENTS from the main menu bar. This window contains all
event information. You may define up to 20 events to run at
any time during the day. In addition to this, it is also
possible to specify that an event only run on a particular
day or days of the week.
To modify an event, simply move the highlight bar to the
event you wish to alter, and press [CR]. Use the cursor keys
to move between entries in the event edit window, and enter
the time you want the event to start at, in 24 hour format.
Next, enter the errorlevel; when the event is activated,
RemoteAccess will exit to the batch file from which it was
called at this errorlevel. Your batch file should trap this
errorlevel and act accordingly. In this window, you can also
specify what days you would like the event to run on, and
whether the event is enabled or disabled. If a user's
upload or download overruns an event which is FORCED then
the transfer will be aborted and the user disconnected to
ensure that the event runs at the proper time. More
information on trapping events is contained in the BATCH
FILE EXAMPLES section.
This page created by ng2html v1.05, the Norton guide to HTML conversion utility.
Written by Dave Pearson