Turbo Pascal compatibility mode

When you compile a program with the -So switch, the compiler will attempt to mimic the Turbo Pascal compiler in the following ways:

• Assigning a procedural variable doesn't require a @ operator. One of the differences between Turbo Pascal and Free Pascal is that the latter requires you to specify an address operator when assigning a value to a procedural variable. In Turbo Pascal compatibility mode, this is not required.
• Procedure overloading is disabled.
• Forward defined procedures don't need the full parameter list when they are defined. Due to the procedure overloading feature of Free Pascal, you must always specify the parameter list of a function when you define it, even when it was declared earlier with Forward. In Turbo Pascal compatibility mode, there is no function overloading, hence you can omit the parameter list:

  Procedure a (L : Longint); Forward;
  
  ...
  
  Procedure a ; { No need to repeat the (L : Longint) }
  
  begin
   ...
  end;

• recursive function calls are handled dfferently. Consider the following example :

  Function expr : Longint;
  
  begin
    ...
    Expr:=L:
    Writeln (Expr); 
    ...
  end;

  In Turbo Pascal compatibility mode, the function will be called recursively when the writeln statement is processed. In Free Pascal, the function result will be printed. In order to call the function recusively under Free Pascal, you need to implement it as follows :

  Function expr : Longint;
  
  begin
    ...
    Expr:=L:
    Writeln (Expr()); 
    ...
  end;

• Any text after the final End. statement is ignored. Normally, this text is processed too.
• You cannot assign procedural variables to void pointers.
• The @ operator is typed when applied on procedures.
• You cannot nest comments.