101	------------------------------------------------------------------------
111	Matrox PowerDesk NT Setup
112	Installation isn't complete. If you cancel the installation, your display software may not work properly.\n\nAre you sure you want to cancel the installation?
113	< &Back
114	&Next >
115	Cancel
116	&Finish
119	Language selected:
120	Devices selected:
121	 (%d devices)
122	Default performance settings will be restored.
123	Installation canceled. Your display software may not work properly. To install properly, run this setup program again.
124	Installation failed. Try restarting your system before running the setup program again. Also, be sure to follow the installation procedure of your Matrox graphics card manual.
125	This software doesn't detect any Matrox graphics hardware in your computer.\n\nMake sure your Matrox graphics hardware is properly installed.
126	Listed below are devices this software has detected in your computer.
127	Default PowerDesk settings will be restored.
128	Unknown Matrox Device
150	Installing...
151	Done
152	Failed
153	Canceled
501	Setup program for Matrox display driver and Matrox PowerDesk software --\n- Operating system: Windows %s; - Date: %d-%02d-%02d; - Time: %d:%02d
502	Command-line and/or INI switches were recognized.
503	No switchs used.
504	Installation summary
505	Miscelleanous
506	Matrox driver defaults restored.
507	"[BOOTUP]" section -- switches added
508	No switchs added.
509	"[REGISTRY]" section -- switches added
510	"[TV_STANDARDS]" section -- switches added
511	Specific display mode (%s x %s, %s-bit, %s dpi) applied.
512	Matrox QuickDesk won't be started when Windows restarts.
513	Matrox Diagnostic won't be started when Windows restarts.
514	The following files were explicitly copied:
515	At %d:%02d, the setup program finished without restarting the computer.
516	At %d:%02d, the setup was cancelled by the user.
517	At %d:%02d, the setup program restarted the computer.
518	No files copied.
519		Source path: %s\n	Destination path: %s
520	The default destination path is "%s".
523	Matrox PowerDesk defaults restored.