101	------------------------------------------------------------------------
1111	Matrox PowerDesk Setup
1112	Installation isn't complete. If you cancel the installation, your display software may not work properly.\n\nAre you sure you want to cancel the installation?
1113	< &Back
1114	&Next >
1115	Cancel
1116	&Finish
1119	Language selected:
1120	Devices selected:
1121	 (%d devices)
1122	Default performance settings will be restored.
1123	Installation canceled. Your display software may not work properly. To install properly, run this setup program again.
1124	Installation failed. Try restarting your system before running the setup program again. Also, be sure to follow the installation procedure of your Matrox graphics card manual.
1125	This software doesn't detect any Matrox graphics hardware in your computer.\n\nMake sure your Matrox graphics hardware is properly installed.
1126	Listed below are devices this software has detected in your computer.
1127	Default PowerDesk settings will be restored.
1128	Unknown Matrox Device
1129	Extra DualHead Multi-Display support
1150	Installing...
1151	Done
1152	Failed
1153	Canceled
1501	Setup program for Matrox display driver and Matrox PowerDesk software --\n- Operating system: Windows %s; - Date: %d-%02d-%02d; - Time: %d:%02d
1502	Command-line and/or INI switches were recognized.
1503	No switchs used.
1504	Installation summary
1505	Miscelleanous
1506	Matrox driver defaults restored.
1507	"[BOOTUP]" section -- switches added
1508	No switchs added.
1509	"[REGISTRY]" section -- switches added
1510	"[TV_STANDARDS]" section -- switches added
1511	Specific display mode (%s x %s, %s-bit, %s dpi) applied.
1512	Matrox QuickDesk won't be started when Windows restarts.
1513	Matrox Diagnostic won't be started when Windows restarts.
1514	The following files were explicitly copied:
1515	At %d:%02d, the setup program finished without restarting the computer.
1516	At %d:%02d, the setup was cancelled by the user.
1517	At %d:%02d, the setup program restarted the computer.
1518	No files copied.
1519		Source path: %s\n	Destination path: %s
1520	The default destination path is "%s".
1523	Matrox PowerDesk defaults restored.