Checking Information of Timelin Clips

Information about the timeline clips (playback timecode, operating mode, audio level) is displayed at the bottom of the screen.



An "R" appears in front of the timecode to indicate timeline timecode (recording side timecode).
The operating mode is shown by marks representing the Play, Cue and other buttons. The speed is displayed in shuttle mode. Audio levels are displayed for two channels.
If you do not want to display this information, select Information Display from the Monitor window Settings menu and then select Hide.

Checking detailed time data

There is a display section at the bottom of the screen to show data about the currently playing timeline clips. It shows the following information.

• Crnt
  Timecode of current position
• In
  Timecode of In point (when an In point exists)
• Out
  Timecode of Out point (when an Out point exists)
• Dur
  Duration timecode
• Tot
  Total length of timeline clips

To change timecode

You can change Crnt, In, or Out timecode shown in the time data display area in units of hours, minutes, seconds, or frames.
To do so, click the digit you want to change, do one of the following.

• Enter a new digit directly (Entering "200" produces 00:00:02;00.)
• Drag the mouse up and down
• Press the up and down arrow keys
• Rotate the mouse wheel

You can also enter offsets by keeping the "+" or "-" key pressed. (The timecode increases or decreases by the entered value.)