When using DVRex-RT

System settings

  • Video Standard
    Click the drop-down list and select your desired video signal format.
  • RT Buffers*
    Click the [] button and select the number of buffer frames to be used for realtime playback.
    Note that restricted-level users cannot change the size of RT Buffers.

    Note

    If you have changed the Video Standard or RT Buffers setting, be sure to exit EDIUS and restart the computer.
  • Default*
    You can revert the settings with an * to their default setting by clicking [Default*].
Output settings

  • DV Format
    Click the [] button and select your desired encoding format for hardware DV codec.
  • Setup Level5 Click the [] button and select your desired setup level for analog output.
  • SyncRec Start Timing*
    Allows you to adjust the timing of starting playback on the computer by the number of frames.
    You can specify a value by either directly typing in or adjusting with the mouse wheel after selecting the input box.
    The default setting is "5".
  • SyncRec End Timing*
    Allows you to adjust the timing of stopping recording on the VCR by the number of frames.
    You can specify a value by either directly typing in or adjusting with the mouse wheel after selecting the input box.
    The default setting is "-5".
  • Record Position*
    Allows you to adjust the position to start recording by the number of steps
    You can specify a value by either directly typing in or adjusting with the mouse wheel after selecting the input box.
    The default setting is "0 (No adjustments)".
  • I/O Box Connection
    Select "Internal" or "External".
  • DV Connector options
    When using DV connector, select which DV connector to use.
Input1/Input2

  • [Brightness*], [Contrast*], [Hue], [Saturation], and [Sharpness] allows you to specify the parameters for the selected video signal format.
    You can specify them by either moving the sliders or directly typing in values (or adjusting values using the mouse wheel after selecting the input box).
  • Setup Level
    Click the [] button and select your desired setup level for analog output.
  • Audio Mapping
    Select a serial port and protocol to use from the list.