═══ 1. Help for Selecting Number of Adapters ═══

Use this window to select the number of Sound Galaxy 16 AUDIO Adapters that you 
have installed in your system. The maximum number of Sound Galaxy 16 AUDIO 
Adapters supported by MMPM/2 is one. 

If you select zero, then you will de-install all Sound Galaxy 16 AUDIO Adapters 
that have been previously installed by MMPM/2. 


═══ 2. Help for selecting 16 bit Audio Board values ═══

On this screen, you specify the values that you want to use with your Sound 
Galaxy 16 AUDIO Adapter.  The values are described below. 

If you choose Close from the system menu, the selected values are set back to 
the default values. 

Select Ok to save the selected values and continue. 

DMA Channel 

This field allows you to select the DMA channel for the Sound Galaxy 16 AUDIO 
you have installed in your system. Use the drop down box to set the correct DMA 
channel for this card. 

The valid DMA Channels are: 

0, 1, and 3 

If the device driver fails to initialize (during system reboot following 
install), it might be necessary to change the DMA channel. To change the DMA 
channel setting: 

Perform a selective installation and select the new DMA channel, 

or 

Edit the CONFIG.SYS, specify the new DMA channel (It is the value immediately 
after the /D on AZT16DD.SYS line of the CONFIG.SYS), and reboot. 

Interrupt Level 

This field allows you to select the interrupt level for the Sound Galaxy 16 
AUDIO you have installed in your system. Use the drop down box to set the 
correct interrupt level for this card. 

The valid interrupt levels are: 

2, 7, and 10, 11 

If the device driver fails to initialize (during system reboot following 
install), it might be necessary to change the interrupt level. To change the 
interrupt level setting: 

Perform a selective installation and select the new interrupt level, 

or 

Edit the CONFIG.SYS, specify the new interrupt level (It is the value 
immediately after the /I on AZT16DD.SYS line of the CONFIG.SYS), and reboot.