Device driver version:  VCN: 849-6.3
____________________________________

NEW OS/2 INSTALLATIONS:  ****************************************************

To install the IN-2000 IN2000.ADD OS/2 2.x/3.x driver, you will need to copy
the IN2000.ADD driver file to a copy of the IBM OS/2 diskette labeled "DISK 1"
(Disk 2 of the Service Pack). If there is not enough free space on the
floppy, you will need to delete some other .ADD driver from the diskette
(one that you will not need for this installation).  You will then need to
modify the CONFIG.SYS on DISK 1 (Disk 2 of Service Pack) to load the driver.
A sample CONFIG.SYS called CONFIG.OS2 has been zipped in with this file to
show how the driver should be loaded.

You may add support for LUNs by adding the "/et" to the IN2000.ADD load line
in config.sys.

** This version of the driver also supports Scatter Gather.

** This driver supports SCSI tape and has been tested with NovaStor's
   NovaBack 2.xx for OS/2 2.x/3.x

This driver will not currently allow you to boot to DOS with ASPI loading and
then loading OS/2.

This driver will also NOT currently allow you to utilize OS2ASPI.DMD under the
OS/2 environment.  This will be fixed in a future revision of the driver.

Some SCSI devices can cause system failures when initiating synchronous data
transfers.  Setting the device to "async" or "sync initiated by host" will
usually resolve this problem.

This version has full support for CD Audio.


UPDATING A PREVIOUS OS/2 INSTALLATION:  *************************************

Go to the SYSTEM SETUP folder which is located in the OS/2 SYSTEM folder.
Double-click on the DEVICE DRIVER INSTALL icon.  You will be shown two options,
one for source and one for target.  Change the SOURCE option to point to the
directory you had decompressed this archive into.  After you do this, then
click on the OK button and a product information screen will be displayed.
Double-click the appropriate product, and the necessary drivers will be
copied to their respective places, and your CONFIG.SYS will be modified.  After
all this, all that is required is that you shutdown and reboot your machine.

If you plan on (or are) using SCSI devices which are NOT CDROMs or hard drives,
you must install the OS/2 SCSI support.  To do this, you need to use the
SELECTIVE INSTALL utility program in the SYSTEM SETUP folder.  Select OTHER for
SCSI card and the necessary drivers will be installed.  MAKE SURE that
OS2ASPI.DMD is NOT added to your CONFIG.SYS.  This is a problem with our
current OS/2 driver and should be rectified in a future version.

If you plan on using CDROM devices, you must install the OS/2 CDROM device
support.  To do this, you must use the SELECTIVE INSTALL utility program in the
SYSTEM SETUP folder.  Select OTHER for CDROM device type and your system will
be modified accourdingly.  MAKE SURE that no *.FLT drivers are added to your
CONFIG.SYS relating to CDROM drives.  These are no longer necessary and will
cause our driver to lockup during boot-up.

This package includes an example CONFIG.OS2 which shows the proper way to use
our drivers under OS/2.