CuSeeMe/2 Support
						  =================

General:
--------

There are two PlugIn modules for CuSeeMe/2, both of which support B&W
and Colour cameras.

1) QV2CUCME.DLL - An Interface between QV2 and CuSeeMe/2.

This requires the QuickCam Viewer, QV2, which must be running to feed
the picture it is currently displaying to the interface. CuSeeMe/2
fetches this picture from the Interface. The advantage is that the
full flexibility of QV2 can be used to size the picture and adjust
camera settings. There is no camera control via the CuSeeMe/2 Local
Video Setup dialog.

2) QVCUSOLO.DLL - A StandAlone plugin which only requires the supplied
device-driver and support DLLs to be available.

This has the advantage that it does nothing until CuSeeMe/2 requests
a picture. The CuSeeMe/2 Setup dialog on the Local Video window
provides support for adjusting camera controls. Where a colour camera
is detected a thumbnail picture is displayed in colour to enable
camera settings to be set accurately.


Installation:
-------------

Note that the installation routine for the QuickCam Viewer, QV2, must
be run to install the device-driver and set appropriate CONFIG.SYS
entries. A reboot will be required to make the changes effective.

Installing the PlugIns for use with CuSeeMe/2 is performed using
CuSeeMe/2 PlugIn Centre.