| From: | Nick Lamburn |
| Date: | 29 May 2000 at 21:03:34 |
| Subject: | Re: Lazy Gfx Card (was Re: Kickstart Show) |
Hi Simon
>> Sorry if I'm going over old ground...
>>
>> Have you tried ShowConfig in the Tools drawer of WBench
>> Have you tried it in any other slots
>> Is it a Z2 fast CV3D and is it in a Z2 Fast Slot
>> Are you dead sure the Z4 bus is working
>
> All seem to check out. However, my set up isn't ideal (M1438s connected to
> the Amiga / SVGA monitor to the gfx card.) There appears to be no
> monitors(cgfx) in the screen prefs selector. It is Z2 fast and in the
> right slot.
IIRC, the Fast Z2 slots are the two below the white NuBus style Z4
connectors. Check the docs to see what you have enabled and that. Do Zorro
cards show up in Ealy Startup? Also just thought of this:
you may need to alter the auto config signals, there are some jumpers on the
Z4 bus. Try altering them.
You need this because an A1200 accelerator doesn't expect to give a
autoconfig output, which it needs to, otherwise no Z2 cards will set
themselves up.
Read the docs on that. There should be some jumpers
> Do I need a scandoubler/flicker fixer? Can I at least get some cgfx modes
> on my M14382s? (I will have to get a 25 to 15 pin cable,though).
No - that's not the problem, scandoubler/flickerfixwer I mean :)
> Cheers,
> Simon
Regards
Nick.
------------------------------------------------------------------------
BeMANY, where eGroups members SAVE on long distance.
http://click.egroups.com/1/4121/3/_/468125/_/959627188/
------------------------------------------------------------------------
Quote carefully and read all ADMIN:README mails